HP Digital Sender Flow 8500 fn2 - Install accessory into hardware integration pocket

Install an accessory into the hardware integration pocket
You can install a separately-purchaseable HP accessory (for example, a proximity reader, ngerprint reader, or
magnetic-swipe reader) into the integrated hardware integration pocket (HIP).
NOTE: This procedure describes installing a proximity card reader. Steps identied as if applicable might not
apply to other HIP accessories. Always refer to the installation instructions that came with your accessory.
To install an accessory into the HIP, follow these steps:
1. Press the Power button to turn o the product (1), and then disconnect the power cable (2).
2
1
2. Insert a at head screw driver into the groove at the top of the HIP cover and gently pry the cover free; set
the cover aside.
3. Remove the HIP accessory from its packaging and install the accessory into the HIP.
a. Connect the accessory's USB cable into the connector on the left side of the HIP enclosure.
ENWW Install an accessory into the hardware integration pocket 85