Upgrade the rmware
1. From the Home screen on the control panel, select the Reports option, and then select the Conguration/
Status Pages option.
2. Select the Conguration Page option, and then select View. The report lists the current rmware revision
number.
3. See www.hp.com/support, search for your product, and then look for a link to downloads to see if there is a
newer version of rmware available.
4. Copy the new rmware le to a USB storage device, and then plug the USB device into the USB port beside
the control panel.
CAUTION: Make sure to leave the USB storage device plugged into the USB connector until all upgrades
are installed, the product has rebooted, and the Home screen is displayed on the control panel.
5. From the Home screen, select the Support Tools option, select Maintenance, and then select the USB
Firmware Upgrade option.
6. Select Firmware Upgrade Bundle, and then select Install.
The upgrade process can take a few minutes. Starting the product after a rmware upgrade might take up
to 20 minutes.
7. If necessary, repeat the previous two steps to install a second upgrade.
NOTE: You can also upgrade rmware using the HP Embedded Web Server (EWS). Start the EWS, select the
General tab, select Firmware Upgrade in the left navigation pane, and then follow the onscreen instructions to
download a rmware upgrade directly to the product.
108 Chapter 4 Manage the scanner ENWW
To Next Page
Loading...