HP Digital Sender Flow 8500 fn2 - Page 32

3. In the Email and Scan to Network Folder Quick Setup Wizards dialog, click the Email Setup link.
NOTE: If a message displays indicating that the Scan to Email feature is disabled, click Continue to
proceed with the conguration and enable the Scan to Email feature upon completion.
4. On the Congure Email Servers (SMTP) dialog, select one of the following options and complete the steps:
Search network for outgoing email server
NOTE: This option nds outgoing SMTP servers inside your rewall only.
a. Select Search network for outgoing email server, and then click Next.
b. Select the appropriate server from the Congure Email Server (SMTP) list, and then click Next.
c. Select the option that describes the server’s authentication requirements:
–
Server does not require authentication: Select Server does not require authentication, and then
click Next.
-OR-
–
Server requires authentication: From the drop-down list, select an authentication option:
○
Use credentials of user to connect after Sign In at the control panel: Select Use credentials
of user to connect after Sign In at the control panel, and then click Next.
-OR-
○
Always use these credentials: Select Always use these credentials, enter the User name
and Password, and then click Next.
22 Chapter 2 Use the scanner ENWW