Troubleshooting
D-12 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: i-appd Troubleshooting.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/11/02 11:23 AM
Table D-4: Problems After Initial Startup continued
Problem Possible Cause Possible Solution
Hard drive controller
order is incorrect.
Run RBSU by pressing the F9 key and correct
this problem.
Encountered problem
after new hardware was
added to the system.
Refer to the documentation provided with the
hardware.
Remove the new hardware.
Problem was
encountered with
hardware added to a
system with a
factory-installed
operating system.
The factory-installed operating system software
installation must be completed before adding
new hardware to the system.
Be sure that all instructions provided in the HP
Factory-Installed Operating System Software
Installation Guide are being followed.
Remove the new hardware and complete the
software installation. Then, reinstall the new
hardware.
Note: Refer to Chapter 4, “Server Configuration and Utilities,” or refer to the ROM-Based Setup
Utility User Guide, for complete instructions on the use of RBSU.
To Next Page
Loading...
