Updating the docking monitor
Downloading the HP rmware installer
1. Go to http://www.hp.com/support.
2. Select Get software and drivers, and follow the on-screen instructions to nd your docking monitor.
3. Follow the on-screen instructions to select and download the HP rmware installer.
4. Complete the installation wizard.
5. Choose to restart now or later. The docking station might not work until the next restart. If you choose
to restart the computer, remove any removable media from the computer and then select Finish.
To update the docking monitor rmware while connected to your computer:
1. Open Windows Explorer and navigate to where you saved the HP rmware installer.
2. Double-click HPFirmwareInstaller.exe.
3. Verify that updates are available, and then select which updates to install.
TIP: You must be connected to the Internet for new updates to download to the HP rmware installer.
4. Select one of the following:
● Update now: Installs the update immediately.
NOTE: Do not disconnect your computer from the docking monitor during an update. You might
see your monitor icker and hear some audio clicks, your Internet connection might be
intermittent, and your mouse and keyboard could become unresponsive until installation is
complete.
● Update on dock disconnect: Installs the update after you disconnect your computer from the
docking monitor.
NOTE: Do not connect your computer to the docking monitor during an update. The dock power light
might blink while the update is being installed.
5. Select Install.
26 Chapter 2 Using the monitor
To Next Page
Loading...
Need help?
General