HP Engage Go 10 User Manual

Multi-charger components
You can charge up to four mobility head units in the multi-charger. To identify charger features, use this
illustration and table.
NOTE: You can only use the multi-charger with mobile system with grip models and convertible system
with grip models.
Table 2-5 Identifying the multi-charger features
Features
1 Locking dial 4 Power light
2 RJ-45 (network) jack 5 Power connector
3 Power switch 6 Security cable slot
Connecting an AC adapter to power
To connect an AC adapter to the I/O connectivity base, use this procedure and illustration.
▲ To connect an AC adapter to the I/O connectivity base, connect one end of the power cord to the AC
adapter (1) and the other end to a grounded AC outlet (2), and then connect the AC adapter to the power
connector on the I/O connectivity base (3).
▲ To connect an AC adapter to the mobility system when it is not connected to an I/O connectivity base,
connect the AC adapter to a grounded AC outlet (1), and then connect the power adapter’s USB Type-C
connector to the USB Type-C power port on the underside of the stand or stability base (2).
NOTE: The power light illuminates when a valid AC adapter is used. If an invalid AC adapter is used, the
light does not turn on, even if the adapter is plugged into a wall socket.
Multi-charger components
9

HP Engage Go 10 Specifications

General

Display Size	10.1 inches
Display Type	IPS
Operating System	Windows 10 IoT Enterprise
Display Resolution	1920 x 1200 pixels
RAM	4GB
Storage	64GB
Connectivity	Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 5.0
Ports	USB-C, USB-A, Audio Jack
Security	Kensington lock slot