Regulatory information is located in the base plate or wall mount. To see this information, you must
disassemble the base plate or wall mount. Be sure to install the base plate or wall mount back after
disassembly.
Installing a security cable on the I/O connectivity base
You can secure the I/O connectivity base to a xed object with an optional keyed security cable lock and an
optional security cable available from HP.
NOTE: The security cable is sold separately as an aftermarket option kit only.
1. Locate the security cable slot on the back of the I/O connectivity base.
2. Insert the security cable lock into the slot, and then use the key to lock it.
Installing a security cable on the mobile system column
You can secure the I/O connectivity base to a
xed object with an optional security cable and an optional
security cable lock available from HP.
NOTE: The security cable lock and security cable are sold separately as an aftermarket option kit only.
1. Remove the screw from the bottom of the column (1).
2. Attach the security cable lock to the bottom of the column using the tamper-resistant screw (2) included
with the security cable extension.
3. Secure the other end of the security cable lock with a security cable (3), and then lock it in place with the
key.
12 Chapter 2 Computer features
To Next Page
Loading...
Need help?
General
