HP Engage Go 10 User Manual

45 pages

To Next Page

To Previous Page

4. Connect the USB Type-C power cable to the USB Type-C port on the underside of the stand column.

5. Place the I/O connectivity base onto the bottom of the stand (1), and then tighten the four screws on the

underside of the I/O connectivity base (2) to secure the I/O connectivity base to the dock. Be sure that

the USB Type-C power cable is routed through the gap between the back of the I/O connectivity base and

the stand.

16 Chapter 3 Hardware setup

Other manuals for HP Engage Go 10

Need help?

Do you have a question about the HP Engage Go 10 and is the answer not in the manual?

General