31 PCIe cardThumbscrew
2 4PCIe card holder Riser card
b) Open the PCIe card holder.
31 Rubber tabPCIe card
2 4Connector PCIe cage slot
c) Pull the PCIe card straight out of the card slot.
7. Insert the new PCIe card.
a) Insert the new PCIe card into the card slot.
b) Align the rubber tabs with PCIe cards, and close the PCIe card holder.
c) Tighten the thumbscrew to secure the PCIe card.
8. Install the PCIe cage into the controller.
• For the primary cage (left), proceed to Step 9.
• For the secondary cage (right), proceed to Step 10.
9. Install the primary PCIe cage (left) into the controller.
a) Align the PCIe cage and guide post with the grooves of the controller, and lower the cage into the controller.
Maintenance Procedures 81
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
