31 Riser cardGuide post
2 Groove
b) With the riser card and connector properly aligned, press down on the top of the PCIe cage to seat the riser card in
the connector.
c) Press down on the fastener and turn the fastener tab one half turn (180°) clockwise to secure the PCIe cage.
10. Install the secondary PCIe cage (right), if present, into the controller.
a) Align the PCIe cage and guide post with the grooves of the controller, and lower the cage into the controller.
Maintenance Procedures 82
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
