Hardware options installation 38
5.
Remove the two metal brackets from the drive carrier.
6. Install the drive in the carrier.
7. Install the drive.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
8. Connect each power cord to the server.
9. Connect each power cord to the power source.
10. Power up the server (on page 17).
11. If removed, install the security bezel ("Security bezel option" on page 36).
To configure arrays, see the HPE Smart Storage Administrator User Guide on the Hewlett Packard
Enterprise website (http://www.hpe.com/info/smartstorage/docs).
Installing a hot-plug drive
To Next Page
Loading...
