Hardware options installation 40
2 LFF Smart Array Controller Mini-SAS cable option
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
1. If installed, remove the security bezel (on page 17).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o Extend the server from the rack (on page 18).
o Remove the server from the rack (on page 19).
5. Remove the access panel (on page 20).
6. Disconnect the existing Mini-SAS cables from the system board and the drive backplane.
7. Remove the existing PCI riser cage ("Remove the PCI riser cage" on page 22).
8. Remove the blank from slot 2 of the riser cage.
9. Install the Smart Array controller.
To Next Page
Loading...
