Hardware options installation 39
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To install the component:
1. If installed, remove the security bezel (on page 17).
2. Remove the drive blank.
3. Prepare the drive.
4. Install the drive.
5. Determine the status of the drive from the drive LED definitions ("HPE SmartDrive LED definitions"
on page 15).
6. If removed, install the security bezel ("Security bezel option" on page 36).
To configure arrays, see the HPE Smart Storage Administrator User Guide on the Hewlett Packard
Enterprise website (http://www.hpe.com/info/smartstorage/docs).
Drive cable options
Use these drive cable options to install a Smart Array Controller option.
To Next Page
Loading...
