HP hpe proliant dl20 gen9 - Two-Slot PCI Riser Cage Assembly

Hardware options installation 70
13.
Connect each power cord to the power source.
14. Power up the server (on page 17).
15. If removed, install the security bezel ("Security bezel option" on page 36).
Two-slot PCI riser cage assembly
For more information on the riser board slot specifications, see "PCIe riser board slot definitions (on page
10)."
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
1. If installed, remove the security bezel (on page 17).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o Extend the server from the rack (on page 18).
o Remove the server from the rack (on page 19).
5. Remove the access panel (on page 20).
6. Remove the existing PCI riser cage ("Remove the PCI riser cage" on page 22).
7. Remove the blank and T-10 screw from the slot of the riser cage.
o Slot 1
o Slot 2
Retain the blank for future use.
8. Install the expansion board and secure it with a screw.