Hardware options installation 50
9.
Install the Smart Storage Battery, and then connect the battery cable to the system board connector.
10. Install the air baffle (on page 24).
11. Install the access panel (on page 21).
12. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack ("Installing the server into the rack" on page 30).
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server (on page 17).
16. If removed, install the security bezel ("Security bezel option" on page 36).
M.2 SSD SATA cable and optical drive extension
power cable option
Installing one M.2 SSD and one optical drive
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
1. If installed, remove the security bezel (on page 17).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o Extend the server from the rack (on page 18).
o Remove the server from the rack (on page 19).
5. Remove the access panel (on page 20).
To Next Page
Loading...
