4 Technical Information
Configuring Your Network Connection
94 English
Configuring Your Network Connection
Use the information in this section if your PC Workstation comes with
an HP-supplied integrated network solution.
You must use the PC Workstation's Setup program (described on page
92) to change the integrated Ethernet interface settings. The following
table summarizes which network options you can set using the Setup
program.
Controlling the Network Security Features
The Security Features allow you to enable starting from the network if
you want the PC Workstation to start from a LAN server.
To enable starting from the network:
1 With the Setup program running (see page 92), use the or
key to select the Security menu.
1. For full information on setting up your network, refer to the online Network Administrator’s
Guide which comes with your PC Workstation.
Network Setup Items
1
Where to find in Setup
Enable the integrated network interface. In the Advanced menu, go to the Integrated
Network Interface submenu.
Enable your PC Workstation to be started (booted
and logged on) from the network.
In the Security menu, go to the Boot Devices
Security submenu (described below).
Enable remote power-on of your PC Workstation. In the Power menu, enable the Integrated
Network item.
From “Suspend Wakeup” mode, enable your PC
Workstation to return to full power when a
command is received by the integrated network
interface.
In the Power menu, enable the Integrated
Network item.
Determine boot device priority. In the Boot menu, select the Boot Device
Priority list item (described on the next page).
napa.bk : napa-ug4.fb4 Page 94 Monday, August 4, 1997 7:20 PM
To Next Page
Loading...
Need help?
General
