1 Setting Up and Using Your PC Workstation
Connecting to a Network
4
Connecting to a Network
Your PC Workstation has a 10BT/100TX LAN interface adapter.
The LAN adapter supports both 10 Mbit/s and 100 Mbit/s operations
and automatically detects which network type is being used.
1 Connect the RJ-45 plug on your network cable to the LAN connector
on the LAN Adapter. Push the plug into the connector until the plug
clicks into place.
2 Attach the other end of the LAN cable to a hub (or into a wall socket
that is connected to a hub).
Let your Network Administrator know that you are connecting your
PC Workstation to the network. Enable the LAN connection through
the Advanced menu of the HP Setup program (see page 92). Refer
also to the online Network Administrator Guide (provided with the
driver kit) for further instructions on setting up your PC
Workstation for a LAN connection.
napa.bk : napa-ug1.fb4 Page 4 Monday, August 4, 1997 7:20 PM
To Next Page
Loading...
Need help?
General
