3 Troubleshooting Your PC Workstation
If Your PC Workstation Does Not Start Properly
56 English
4 Check the following items:
5 Replace the cover.
6 Reconnect all cables and power cords.
7 Turn on the display and computer.
Rebuild Your PC
Workstation’s
Components
If your PC Workstation still does not start properly, remove all boards
and accessories, except the hard disk drive and video board. Start the
PC Workstation. If the PC Workstation now works, add the boards and
accessories one at a time to determine which one is causing the
problem.
If a POST Error Message is Displayed
The Power-On-System-Test (POST) can detect both an error and a
change to the configuration. In either case, an error code and short
description is displayed. Depending on the kind of error, you will have
one or more of these choices available on screen:
• Press to ignore the message and continue.
• Press to run Setup and correct a system configuration error. HP
recommends that you correct the error before proceeding, even if
the PC Workstation appears to start successfully.
• Press to accept (validate) the change and update Setup’s
configuration information.
Action Reference
Check all internal cables. Ensure they are correctly attached and firmly in place.
Check that the processor is correctly
installed.
Refer to “Installing a Processor” on page 50.
Check that the processor speed
switches have been set correctly.
Refer to “System Board Switches” on page 90.
Check that the memory modules are
correctly installed.
Refer to “Installing Memory” on page 26.
Check that accessory boards are firmly
seated in their slots.
Refer to “Installing Accessory Boards” on page 45.
Verify that any switches and jumpers on
the accessory boards are properly set.
Refer to the manuals that came with each board.
Check that the switches on the system
board are properly set.
Refer to “System Board Switches” on page 90.
napa.bk : napa-ug3.fb4 Page 56 Monday, August 4, 1997 7:20 PM
To Next Page
Loading...
Need help?
General
