Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-21 Computer Setup—Boot
Option Description
Boot-time
Diagnostic
Screen
Disables/enables POST diagnostic messages display during boot. Default is disabled.
Boot Device
Priority
Allows you to specify which device groups will boot first, second, third, and fourth or to disable any of
the four. Also allows you to set the device boot priority within each group.
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
Allows you to set the device group boot priority:
●
CD-ROM Group
●
Hard Drive Group
●
Floppy Group
●
Network Boot Group
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS
operating system has started.
Floppy Group
Boot Priority
Specifies boot device priority within removable devices.
NOTE: This computer does not support floppy drives.
CD-ROM Group
Boot Priority
Specifies boot device priority within CD/DVD drives.
HDD Group Boot
Priority
Specifies boot device priority within hard drives.
Network Group
Boot Priority
Specifies boot device priority within bootable network devices.
ESC: Boot Menu
Allows you to enable/disable the option to press the ESC key to access the Boot menu during computer
startup. Default is enabled.
F9: Diagnostics
Disables/enables the F9 Boot Menu prompt message on the logo screen. Default is enabled.
F10: Setup
Disables/enables the F10 Setup prompt message on the logo screen. Default is enabled.
F11: Recovery
Disables/enables the F11 Recovery prompt message on the logo screen. Default is enabled.
F12: Boot from
LAN
Disables/enables the F12 Boot from LAN prompt message on the logo screen. Default is enabled.
28 Chapter 2 Computer Setup (F10) Utility
To Next Page
Loading...
Need help?
General