Front I/O Assembly
The front I/O assembly is attached to the front of the chassis. Pull the assembly away from the chassis
to remove it.
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 87).
2.
Remove the access panel (
Access Panel on page 88).
3.
Remove the front bezel (
Front Bezel on page 89).
4.
Remove the system fan (
System Fan on page 103).
5.
Disconnect the front audio and front USB cables from the yellow and white system board
connectors.
6.
Remove the cables from the clips on the base of the computer.
Figure 6-30 Front I/O assembly cable clip locations
Front I/O Assembly
117
To Next Page
Loading...
