1. Use the leverage point (1) to swing the front chassis (2) up and toward the front of the computer.
2. Disconnect the hard drive power cable (1) from the hard drive.
3. Disconnect the hard drive data cable (2) from the hard drive.
4. Remove the three Torx15 screws (3) that secure the hard drive to the drive cage.
5. Remove the hard drive (4) from the drive cage.
6. Release the drive power cable from the retention clip (1) that is built into the main chassis.
7. Release the drive data cable from the retention clip (2) that is built into the main chassis.
8. Disconnect the drive power cable (3) from the system board.
28
Chapter 4 Removal and replacement procedures
To Next Page
Loading...
