9. Disconnect the drive data cable (4) from the system board.
10. Remove the hard drive drive cables from the computer.
To install the hard drive and hard drive cables, reverse the removal procedure.
Speaker
To remove the speaker, use these procedures. A single speaker is located on the left side of the
computer behind the front bezel, inside the chassis.
Table 4-5
Speaker description and part number
Description Spare part number
Speaker N04504-001
Before removing the speaker, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 22).
2. Remove the access panel (see Access panel on page 23).
3. Remove the optical drive (see Optical drive on page 25).
4. Remove the front bezel (see Front bezel on page 26).
Remove the speaker:
1. Disconnect the speaker cable (1) from the system board.
2. Release the speaker cable from the retention clip (2) that is built into the system chassis.
Speaker
29
To Next Page
Loading...
