Solid-state drive
To remove the solid-state drive, use these procedures. The system board offers two solid-state drive
slots.
Table 4-7 Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, PCIe-4 × 4, TLC M52027-001
1 TB, PCIe-4 × 4, TLC M16560-001
1 TB, PCIe L85370-001
1 TB, PCIe-4 × 4, TLC, NMIC N22908-001
512 GB, PCIe-4 × 4, TLC M17436-001
512 GB, PCIe-4 × 4, TLC, self-encrypting drive (SED) M52031-001
512 GB, NMIC N24955-001
512 GB L85364-001
256 GB, PCIe-4 × 4, TLC, self-encrypting drive (SED) M52029-001
256 GB, PCIe-4 × 4, NMIC N30732-001
256 GB, PCIe-4 × 4, TLC M52025-001
256 GB L85354-001
128 GB, PCIe-4 × 4 N42382-001
Solid-state drive heat sink N02705-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 22).
2. Remove the access panel (see Access panel on page 23).
Remove the solid-state drive:
32
Chapter 4 Removal and replacement procedures
To Next Page
Loading...
