HP ProCurve 3500yl Series User Manual

RADIUS Authentication and Accounting
Messages Related to RADIUS Operation
Messages Related to RADIUS Operation
Message Meaning
Can’t reach RADIUS server < x.x.x.x >. A designated RADIUS server is not responding to an
authentication request. Try pinging the server to determine
whether it is accessible to the switch. If the server is
accessible, then verify that the switch is using the correct
encryption key and that the server is correctly configured
to receive an authentication request from the switch.
No server(s) responding. The switch is configured for and attempting RADIUS
authentication, however it is not receiving a response from
a RADIUS server. Ensure that the switch is configured to
access at least one RADIUS server. (Use show radius.) If
you also see the message Can’t reach RADIUS
server < x.x.x.x >, try the suggestions listed for
that message.
Not legal combination of authentication Indicates an attempt to configure local
as both the primary
methods.
and secondary authentication methods. If local is the
primary method, then none must be the secondary method.
6-36

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports