HP ProCurve 3500yl Series User Manual

Virus Throttling
Basic Connection-Rate Filtering Configuration
Viewing and Managing Connection-Rate Status
The commands in this section describe how to:
■ View the current connection-rate configuration
■ List the currently blocked hosts
■ Unblock currently blocked hosts (on a per-VLAN basis).
Viewing the Connection-Rate Configuration
Use the following command to view the basic connection-rate configuration.
If you need to view connection-rate ACLs and/or any other switch configura-
tion details, use show config or show running (page
3-17).
Syntax: show connection-rate-filter
Displays the current global connection-rate status
(enabled/disabled) and sensitivity setting, and the cur-
rent per-port configuration. This command does not
display the current (optional) connection-rate ACL con-
figuration, if any.
Per-Port configuration for
connection-rate filtering
Figure 3-4. Example of Displaying the Connection-Rate Status, Sensitivity, and Per-
Port Configuration
3-16

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports