HP ProCurve 3500yl Series User Manual

Configuring Port-Based and Client-Based Access Control (802.1X)
Operating Notes
Operating Notes
■ Applying Web Authentication or MAC Authentication Concur-
rently with Port-Based 802.1X Authentication: While 802.1X port-
based access control can operate concurrently with Web Authentication
or MAC Authentication, port-based access control is subordinate to Web-
Auth and MAC-Auth operation. If 802.1X operates in port-based mode and
MAC or Web authentication is enabled on the same port, any 802.1X
authentication has no effect on the ability of a client to access the
controlled port. That is, the client’s access will be denied until the client
authenticates through Web-Auth or MAC-Auth on the port. Note also that
a client authenticating with port-based 802.1X does not open the port in
the same way that it would if Web-Auth or MAC-Auth were not enabled.
That is, any non-authenticating client attempting to access the port after
another client authenticates with port-based 802.1X would still have to
authenticate through Web-Auth or MAC-Auth.
10-57

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports