HP ProCurve 3500yl Series User Manual

Configuring Username and Password Security
Front-Panel Security
3. Release the Reset button.
Reset Clea
Tes
t
4. When the Test LED to the right of the Clear button begins flashing, release
the Clear button.
.
Reset Clea
Tes
t
It can take approximately 20-25 seconds for the switch to reboot. This process
restores the switch configuration to the factory default settings.
Configuring Front-Panel Security
Using the front-panel-security command from the global configuration context
in the CLI you can:
• Disable or re-enable the password-clearing function of the Clear
button. Disabling the Clear button means that pressing it does not
remove local password protection from the switch. (This action
affects the Clear button when used alone, but does not affect the
operation of the Reset+Clear combination described under
“Restor-
ing the Factory Default Configuration” on page 2-11.)
2-12

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports