HP ProCurve 3500yl Series User Manual

Configuring Username and Password Security
Configuring Local Password Security
Configuring Local Password Security
Menu: Setting Passwords
As noted earlier in this section, usernames are optional. Configuring a user-
name requires either the CLI or the web browser interface.
1. From the Main Menu select:
3. Console Passwords
Figure 2-1. The Set Password Screen
2. To set a new password:
a. Select Set Manager Password or Set Operator Password. You will then
be prompted with Enter new password.
b. Type a password of up to 16 ASCII characters with no spaces and
press
[Enter]. (Remember that passwords are case-sensitive.)
c. When prompted with Enter new password again, retype the new pass-
word and press [Enter].
After you configure a password, if you subsequently start a new console
session, you will be prompted to enter the password. (If you use the CLI or
web browser interface to configure an optional username, the switch will
prompt you for the username, and then the password.)
2-5

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports