HP ProCurve 3500yl Series User Manual

Configuring Secure Socket Layer (SSL)
Configuring the Switch for SSL Operation
Using the web browser interface To Configure Local Passwords. You
can configure both the Operator and Manager password on one screen. To
access the web browser interface, refer to the chapter titled “Using the
ProCurve Web Browser Interface” in the Management and Configuration
Guide for your switch.
Password Button
Security Tab
Figure 8-2. Example of Configuring Local Passwords
1. Proceed to the security tab and select device passwords button.
2. Click in the appropriate box in the Device Passwords window and enter
user names and passwords. You will be required to repeat the password
strings in the confirmation boxes.
Both the user names and passwords can be up to 16 printable ASCII
characters.
3. Click on
[Apply Changes] button to activate the user names and passwords.
8-8

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports