HP ProCurve 3500yl Series User Manual

Traffic/Security Filters
Filter Types and Operation
ProCurve(config)# show filter
Traffic/Security Filters
ID X Filter Type | Value
- -- ------------ + -------------------
1 Sourc e Port | 2
2 Sourc e Port | 3
3 Sourc e Port | 4
4 Sourc e Port | 5
5 Sourc e Port | 6
6 Sourc e Port | 8
7 Sourc e Port | 9
8 Sourc e Port | 12
2 0 Sourc e Port | 24
2 1 Sourc e Port | 25
2 2 Sourc e Port | 26
2 3 Sourc e Port | 7
2 4 Sourc e Port | 10
2 5 Sourc e Port | 11
2 6 Sourc e Port | 1
Indicates the port number or port-
trunk name of the source port or trunk
assigned to the filter.
An automatically assigned index
number used to identify the filter for
a detailed information listing. A filter
retains its assigned IDX number for
as long as the filter exists in the
switch. The switch assigns the
lowest available IDX number to a new
filter. This can result in a newer filter
having a lower IDX number than an
older filter if a previous (source-port
or named source-port) filter deletion
created a gap in the filter listing.
Using the IDX value in the show filter command, we can see how traffic is
filtered on a specific port (Value).The two outputs below show a non-
accounting and an accounting switch port.
9-11

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports