HP ProCurve 3500yl Series User Manual

Configuring and Monitoring Port Security
Reading Intrusion Alerts and Resetting Alert Flags
Log Listing with
Security Violation
Detected
Log Listing with No
Security Violation
Detected
Log Command
with
“security” for
Search
Figure 11-19.Example of Log Listing With and Without Detected Security Violations
From the Menu Interface: In the Main Menu, click on
4. Event Log and use
N
ext page and Prev page to review the Event Log contents.
For More Event Log Information. See “Using the Event Log To Identify
Problem Sources” in the “Troubleshooting” chapter of the Management and
Configuration Guide for your switch.
Web: Checking for Intrusions, Listing Intrusion
Alerts, and Resetting Alert Flags
1. Check the Alert Log by clicking on the Status tab and the [Overview] button.
If there is a “Security Violation” entry, do the following:
a. Click on the Security tab.
b. Click on
[Intrusion Log]. “Ports with Intrusion Flag” indicates any ports
for which the alert flag has not been cleared.
c. To clear the current alert flags, click on
[Reset Alert Flags].
To access the web-based Help provided for the switch, click on
[?] in the web
browser screen.
11-41

HP ProCurve 3500yl Series Specifications

General

Model	HP ProCurve 3500yl Series
Switching Capacity	176 Gbps
Layer	Layer 3
Input Voltage	100-240 VAC
PoE	Available on some models
Management	Web, CLI, SNMP
Routing Protocol	RIP, OSPF, BGP
Remote Management Protocol	Telnet
Features	VLAN
Power Consumption Operational	Varies by model
Memory	256 MB
Power Supply	Internal
Security Features	802.1X, RADIUS, TACACS+
Ports	24 or 48 x 10/100/1000Base-T ports