1. Prepare the computer for disassembly (Preparation for disassembly on page 21).
2. Remove the access panel (Access panel on page 21).
Remove the front bezel:
1. Disengage the three tabs (1) on the top of the front bezel from the system chassis.
2. Swing the top edge of the front bezel (2) away from the system chassis.
3. Remove the bezel from the access panel.
To install the front bezel, reverse the removal procedure.
Hood sensor module
To remove the hood sensor module, use these procedures. The hood sensor module is located on the rear panel
of the computer chassis.
Before removing the hood sensor module, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 21).
2. Remove the access panel (Access panel on page 21).
Remove the hood sensor module:
1. Disconnect the hood sensor module cable (1) from the system board.
24 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
