2. Pull the drive out of the system board connector (2).
To install the solid-state drive module, reverse the removal procedure.
NOTE: Solid-state drive modules are designed with a notch to prevent incorrect insertion.
Fan shroud
To remove the fan shroud, use these procedures.
Before removing the fan shroud, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 21).
2. Remove the access panel (Access panel on page 21).
Remove the fan shroud:
1. Release the fan shroud by pressing out on the two release tabs (1).
38 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
