Solid-state drive
To remove the solid-state drive module, use these procedures.
Table 4-4 Solid-state drive module descriptions
Description
1 TB, M.2 2280, NVMe, SuperSpeed (SS) solid-state drive with triple layer cell (TLC)
512 GB, M.2 2280, PCIe, NVMe, SS solid-state drive with TLC
512 GB, M.2 2280, PCIe-3×4, self-encrypting drive (SED) solid-state drive with TLC
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive
256 GB, M.2 2280, PCIe, NVMe, SS solid-state drive with TLC
256 GB, M.2 2280, PCIe-3×4, SED solid-state drive with TLC
256 GB, M.2 2280, PCIe, NVMe, value solid-state drive
128 GB, M.2 2280, PCIe, NVMe solid-state drive with TLC
16 GB, M.2 2280, PCIe-3×2, NVMe solid-state drive with TLC
256 GB, M.2 2280, PCIe + 16 GB 3D solid-state drive
512 GB, M.2 2280, PCIe, NVMe + 32 GB 3D solid-state drive
Before removing the solid-state drive module, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 21).
2. Remove the access panel (Access panel on page 21).
3. Remove the optical drive (Optical drive on page 22).
4. Remove the front bezel (Front bezel on page 23).
5. Release the drive cage (Drive cage on page 29).
Remove the solid-state drive module:
1. Remove the screw that secures the drive (1).
ENWW Solid-state drive 37
To Next Page
Loading...
