7. Type 3: Pull back the clip (1) that is holding the battery in place, and remove the battery (2).
8. Insert the new battery and position the clip back into place.
System board
To remove the system board, use these procedures.
NOTE: All system board spare part kits include replacement thermal material.
NOTE: System board appearance can vary.
Before removing the system board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 21).
2. Remove the access panel (Access panel on page 21).
3. Remove the optical drive (Optical drive on page 22).
4. Remove the front bezel (Front bezel on page 23).
5. Release the drive cage (Drive cage on page 29).
6. Remove the fan shroud (Fan shroud on page 38).
7. Remove the heat sink (Heat sink on page 39).
Remove the system board:
1. Remove the six Torx screws that secure the system board to the system chassis.
46 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
