3. Remove the optical drive (Optical drive on page 22).
4. Remove the front bezel (Front bezel on page 23).
5. Release the drive cage (Drive cage on page 29).
Remove the hard drive:
1. Release the hard drive power and data cables from the retention clips (1) and (2) built into the drive cage.
2. Disconnect the hard drive power cable (3) and data cable (4) from the system board.
3. Pull the release lever outward (1).
4. While pulling the release lever outward, slide the drive to the left (2) until it stops, and then remove the
hard drive from the drive cage.
ENWW Hard drive 31
To Next Page
Loading...
