HP ProLiant BL30p

Battery Replacement
B-2 HP ProLiant BL30p Server Blade Setup and Installation Guide
2. Locate the battery holder on the system board.
3. Push the tab aside, and pull the existing battery straight up.
Figure B-1: Battery holder
WARNING: For proper battery disposal, refer to the “Battery Replacement
Notice” section in Appendix C, “Regulatory Compliance Notices.”
4. To install the new battery, push it into the socket until the tab locks in place.
CAUTION: The battery is keyed to install only with the positive side facing the
tab. Do not force the battery into the socket facing the other direction.
5. Install the server blade in the server blade enclosure. Refer to the “Installing a
ProLiant BL30p Server Blade” section in Chapter 3, “Server Blade Setup.”
6. Power up the server blade. Refer to the “Powering Up the Server Blade” section
in Chapter 2, “Server Blade Operations.”
7. Run RBSU to reconfigure the system with the new battery. Refer to the
“ROM-Based Setup Utility” section in Chapter 6, “Server Blade Configuration
and Utilities.”