HP ProLiant BL30p Setup And Installation Guide

Server Blade Setup
3-6 HP ProLiant BL30p Server Blade Setup and Installation Guide
Removing a ProLiant BL30p Server Blade
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Electrostatic discharge can damage electronic components. Properly
ground yourself before beginning any installation procedure. Refer to Appendix D,
“Electrostatic Discharge,” for more information.
1. Press the release button (1).
2. Open the release lever (2).
3. Grasp the lever and slide the server blade from the server blade enclosure (3).
Place a hand under the server blade to support it as you remove it from the server
blade enclosure.
IMPORTANT: Do not remove the ProLiant BL30p blade sleeve from the server blade
enclosure.
Figure 3-5: Removing a ProLiant BL30p server blade
Place the server blade on a flat, level surface.

HP ProLiant BL30p Specifications

General

Brand	HP
Model	ProLiant BL30p
Category	Server
Language	English