HP ProLiant DL320e Gen8 v2 - Hardware options installation; Introduction; Security bezel option; Drive options

Removal and replacement procedures 34
4.
Remove the power supply.
To replace the component, reverse the removal procedure.
Non-hot-plug drive carrier
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Remove the drive carrier.
To replace the component, slide the component into the bay until it clicks.
Non-hot-plug drive