Removal and replacement procedures 63
8.
Remove the power distribution board.
To replace the component, reverse the removal procedure.
HP CS power supply cage
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 29).
o Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
5. Remove the power supply ("HP CS power supply" on page 33).
To Next Page
Loading...
