Removal and replacement procedures 60
7.
Remove the internal USB connector.
To replace the component, reverse the removal procedure.
Integrated power supply rear cover
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 29).
o Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).
To Next Page
Loading...
