Removal and replacement procedures 53
6.
Identify the expansion slot compatible with the new option, and then remove the cover opposite that
slot.
7. Verify that any switches or jumpers on the expansion board are set properly. For more information, see
the documentation that ships with the option.
8. Install the expansion board. Verify that the board is firmly seated in the slot.
9. Install the PCI riser cage.
IMPORTANT: The server does not power up if the PCI riser cage is not seated properly.
10. Connect all necessary internal cabling to the expansion board. For more information on these cabling
requirements, see the documentation that ships with the option.
11. Install the access panel.
12. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack.
13. Connect all necessary external cabling to the expansion board. For more information on these cabling
requirements, see the documentation that ships with the option.
14. Connect the peripheral devices to the server.
15. Connect the power cord to the server.
16. Connect the power cord to the power source.
17. Power up the server.
PCIe riser board
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
To Next Page
Loading...
