EasyManua.ls Logo

HP ProLiant DL320e Gen8 v2 - Keeping the system current; Access to HP Support Materials; Drivers; Software and firmware

HP ProLiant DL320e Gen8 v2
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Component identification 77
Rear panel LEDs and buttons
Item Description Status
1
NIC link LED Solid green = Link exists
Off = No link exists
2
NIC status LED Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network
active
Off = No network activity
3
Power supply LED Solid green = Normal
Off = One or more of the following conditions
exists:
Power is unavailable
Power supply failed
Power supply is in standby mode
Power supply error
4
UID button/LED Solid blue = Activated
Flashing blue (1 Hz/cycle per sec) = Remote
management or firmware upgrade in progress
Off = Deactivated
PCIe riser board slot definitions
The riser board slots transfer rate is the same for all supported processor models. Both slots will run in PCIe3
(8 GT/s) rate.
Slot number Type Length Height Connector link width Negotiable link width
1
PCIe3 Half Full x16 x8
2
PCIe3 Half Half x8 x4

Table of Contents

Other manuals for HP ProLiant DL320e Gen8 v2

Related product manuals