HP ProLiant DL320e Gen8 v2 - Front I;O Module Assembly; Front Fan Cage Assembly

Removal and replacement procedures 43
6.
Remove the drive cage bracket.
To replace the component, reverse the removal procedure.
Front I/O module assembly
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Remove the access panel ("Access panel" on page 35).
4. Remove the air baffle ("Air baffle" on page 36).
5. Disconnect the front I/O module cable from the system board.
6. Remove the front I/O board.
To replace the component, reverse the removal procedure.
Front fan cage assembly