Removal and replacement procedures 41
o
Four-bay SFF drive model
12. Do one of the following:
o Remove the drive cage backplane.
o Remove the drive cage bracket ("Non-hot-plug drive cage bracket" on page 42).
If you are replacing the drive cage with a new one, install the serial number/iLO information pull tab
removed in step 9 on the new drive cage before installing it in the chassis.
To replace the component, reverse the removal procedure.
Hot-plug drive cage backplane
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Remove all drives ("Hot-plug drive" on page 32, "Non-hot-plug drive" on page 34).
4. Remove the server from the rack (on page 30).
5. Remove the access panel ("Access panel" on page 35).
6. If you are removing the two-bay LFF drive backplane:
a. Remove the drive cage assembly.
To Next Page
Loading...
