HP ProLiant DL320e Gen8 v2 - Installing the FBWC module and capacitor pack

Removal and replacement procedures 39
o
Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).
5. Do one of the following:
o Disconnect the Mini-SAS cable from the system board, and then disconnect the cable from the drive
cage.
o Disconnect the Mini-SAS cable from the expansion board, and then disconnect the cable from the
drive cage.
To replace the component, reverse the removal procedure.
Drive cage assembly
To remove the component:
1. Power down the server (on page 28).