Removal and replacement procedures 61
5.
Remove the integrated power supply rear cover.
To replace the component, reverse the removal procedure.
Integrated power supply
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Remove the server from the rack (on page 30).
4. If the server is installed in a friction rail system, remove the friction rails from the chassis. For more
information, see the documentation that ships with the rail system.
5. Remove the access panel ("Access panel" on page 35).
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
6. Disconnect all power supply cables from the system board and drive cage.
To Next Page
Loading...
