HP ProLiant DL320e Gen8 v2 - Internal USB Connector

Removal and replacement procedures 59
10.
Remove the fan assembly.
To replace the component, reverse the removal procedure.
Internal USB connector
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 29).
o Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).
5. If an expansion board is installed in the riser board slot 1, remove the PCI riser cage ("PCI riser cage"
on page 51).
6. Disconnect the internal USB connector cable from the system board.