Removal and replacement procedures 40
2.
Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Remove all drives ("Hot-plug drive" on page 32, "Non-hot-plug drive" on page 34).
4. Remove the server from the rack (on page 30).
5. If the server is installed in a friction rail system, remove the friction rails from the chassis. For more
information, see the documentation that ships with the rail system.
6. Remove the access panel ("Access panel" on page 35).
7. Do one of the following:
o Remove the optical drive ("Optical drive" on page 37).
o Remove the optical drive blank. Retain the blank for future use.
8. If an HP CS power supply is installed, remove the power supply distribution board ("HP 750 W CS -48
V DC power supply enablement kit" on page 62).
9. If you are replacing the drive cage with a new one, remove the serial number/iLO information pull tab
from the front panel. Retain this pull tab for installation in the new drive cage.
10. Disconnect all cables from the drive cage.
11. Remove the drive cage assembly:
o Two-bay LFF drive model
To Next Page
Loading...
