Physical Disk 0 Physical Disk 1
gl0058
Logical Disk 2
DON’T ERASE Volume
RAID 1
Logical Disk 1
Operating System Volume
RAID 1
Figure 15 DL380 G5 hardware RAID
Table 11 provides additional information about the drive configuration.
Table 11 DL380 G5 two-HDD configuration
Logical
disk
RAID level
Size/allocation
Purpose
1
RAID 1
15 GB across physical drive
0, 1
Primary OS
2
RAID 1
5GBacrossphysicaldrive0,
1
DON’T
ERASE
NOTE:
In the HP Array Configuration Utility (AC U) , logical disks are labeled 1 and 2. In Disk M anager,
logicaldisksaredisplayedas0and1. TheACUuserguideisavailablefordownloadat
h
ttp://h20000.www2.hp.com/bc/docs/s upp ort/SupportManual/c00294139/c00294139. pdf.For
HP Smart Array configuration information, the P400 controller user guide can be obtained from
h
ttp://h20000.www2.hp.com/bc/docs/s upp ort/SupportManual/c00572169/c00572169.pdf.
NOTE:
The DON’T ERASE logical disk supports the recovery process only and doe s not host the secondary
operating system. If you need to perform a sys tem recovery for your server, see the instructions inside the
HP ProLiant Storage Server System Installation and Recovery DVD. Be sure to back up your user data,
and then use the DVD to r estore the server to the factory default state.
Data volumes are not carved at the factory or by the System Installation and Recovery DVD, and must be
configu
redmanuallybytheenduser.
If the o
perating system has a failure that might result from corrupt system fi les, a corrupt registry, or the
syste
m hangs during b oot, refer to "System installation and recovery" on page 143.
Be sure to back up your user data, and then use the System Installation and Recovery DVD to restore the
server to the factory default state as soon as conveniently possible.
External storage drives
TheMSA20storageenclosurefortheDL380G52TBStorageServerisconfigured for hardware RAID
fault tolerance using the HP Smart Array 6402 RAID Controller. The SATA HDD s are hot-plugg able and
hot-swappable.
HPProLiantDL380G5StorageServer 39
To Next Page
Loading...
